Whirlpool Gas Dryer Not Heating Up. Replace the faulty igniter with a new one. Remove the motor cover by removing two screws.
Whirlpool Gas Dryer Repair Does not heat properly LGB6200PQO YouTube from www.youtube.com
Be sure to clean out the lint screen with every use. If you have a whirlpool gas dryer, make sure to check the gas is turned on and connected properly. Plug in the dryer and run a test to see if the dryer is heating up now.
Remove The Old Igniter And Replace It With A New One.
Reattach the wires onto the new thermostat and install the panel back to position. Next, reach under the drum and rethread the drive belt around the idler pulley and motor pulley in a “z” formation. Screw in the new cycling thermostat to replace the one that was previously malfunctioning.
Unscrew The Front Mounting Bracket And Pull Out The Broil Element.
If the coils become defective, it brings all heating to an abrupt stop. Attach it with the screws you just removed. “no continuity” indicates a bad heating element.
Place The Front Panel Back On Your Dryer, And Rethread The Panel Screws To.
A bad dryer heating element will have a break in the coil. Disconnect wires from the heating element by using wire nuts to connect the incoming white and black wires coming from the. Hi and thanks for watching.
Make Sure The Dryer Is Connected To The Gas Supply.
First, retrieve your dryer drum and carefully guide it back into the appliance cabinet. How to replace dryer gas valve coil kit for whirlpool wgd5300vw0 no heat or not enough heat #ap3094251. Now, unplug the dryer from the electric power outlet and cut off the gas supply.
The Heating Circuit Controls These Coils, Which Can Be Located At The Top Of The Gas Valve.
A close inspection is required as some breaks tend to hide among the coils. Basically was going to pay a repairman to come out $100. Slide the new heating element back.
Location:
Share :
Post a Comment
for "Whirlpool Gas Dryer Not Heating Up"
Post a Comment for "Whirlpool Gas Dryer Not Heating Up"